ssgutor
Posts: 1
Joined: Sun May 09, 2021 7:26 pm

Is Replicator 2x worth reanimating it?

I need an advice from experienced people. I got in my hand MakerBot Replicator 2x and wondering is it worth reanimating or should I spend probably even less money on new printer? I’m not familiar with the field much. Is technology went far further since 2013 and an old printer completely outdated?

I printed extruders for it, leveling is manual, bad itself a bit warped. When prints it stops in the middle for no reason. Loading of filament and a little bit of pushing - it works again. Tip of plastic that comes afterwards looks burned.

I’ll appreciate any comments and suggestions!

Return to “Troubleshooting and Bug Reports”