andyc
Posts: 8
Joined: Sun Aug 05, 2018 10:08 am

Specifying prime pillar extruder duplicates / overprints pillar

Mon Jun 21, 2021 3:17 am

I've come across a strange issue where specifying the prime pillar extruder as Right Extruder only causes the pillar to be printed once per feature instead of once per line.

As can be seen in the attached test case during the Left Extruder potion the pillar is printed correctly, but once it reaches the Right Extruder potion the pillar is overprinted 3 times per layer.
Attachments
prime-pillar-issue.zip
Test case for prime pillar issue
(21.06 KiB) Downloaded 32 times

S3D-Rick
Posts: 22
Joined: Thu Jul 30, 2020 11:09 am

Re: Specifying prime pillar extruder duplicates / overprints pillar

Wed Jun 30, 2021 1:31 pm

In general, the prime pillar should be set to "All Extruders", and the software will choose when to prime the extruders.

Return to “Troubleshooting and Bug Reports”