I do want to try one more thing before I actually give up completely.
Hopefully someone can answer this:
The one main thing I can't figure out is why, when switching extruders, the 'new' extruder goes to the last place the 'old' one was, extrudes out a little filament, *then* goes back to its 'home' (like I tell it in the gcode) and extrudes filament like I ask it to.
Both sides do this, and I can't find where this setting/gcode command is to stop it from happening.
Just to reiterate, when it's time to switch colors/extruders, this is what happens:
1) The 'old' extruder lifts up, and moves back to its home.
2) The 'new' extruder now moves to the last place the 'old' extruder was, and lets out a little filament <- This is what I can't find
3)The 'new' extruder moves back to its home, and extrudes a bit of filament to replace any that may have oozed out while idle
4) The 'glob' of filament that the 'new' extruder left where the 'old' filament left off causes an issue with the rest of the print.
This happens for either extruder when switching.
I have included the .FFF file here. Please, if someone can help here, I would greatly appreciate it.
- (24.58 KiB) Downloaded 127 times