Posts: 211
Joined: Wed Jul 19, 2017 9:37 am

Re: Gaps in Perimeters (Again)

Sun Aug 22, 2021 5:50 pm

I haven't had a chance to try it yet, but I made a grooved roller to use the MakerGear extruder with TPU: ... =10#p36804

Thanks for the tip on 3DFuel's PLA. Their PLA Pro is about 50% more expensive than eSun. Given that I don't have issue with the eSun PLA+ stuff, what can I expect to get for the extra $$? I notice it prints at a slightly higher temperature, which could be good as long as it doesn't warp too much. It also has tighter diameter tolerance, although as I said, that's never been an issue for me with eSun.

Return to “Troubleshooting and Bug Reports”