DaSouli
Posts: 1
Joined: Fri Aug 27, 2021 1:24 pm

Thick points at layer change

Hi guys,

since i use my new Artillery Sidewinder X1 an Simplify3D, i have thick points/lines on the walls of my prints (see attachment). I think this is, where the layer change happens. Anyone can give me an advice, which settings i have to adjust to reduce this? Estep and layer change is configured prefectly for the used filament.
20210827_192624.jpg
Thanks in advance!
S3D-Alex
Posts: 456
Joined: Thu Aug 30, 2018 1:23 pm

Re: Thick points at layer change

These look like blobs and zits so I would first suggest looking over the solutions we have in our Print Quality Guide on this topic but please let me know if you need further assistance:

https://www.simplify3d.com/support/prin ... -and-zits/

Return to “Troubleshooting and Bug Reports”