Extruder 2, wrong direction
Posted: Thu Sep 23, 2021 9:38 pm
by fmeroney
Hello, I have a Makergear M2 Dual. Im trying to print with the right extruder for the first time but instead of extruding its retracting... Ant way to change that setting in Simplify3D or is this a firmware change?
Re: Extruder 2, wrong direction
Posted: Fri Sep 24, 2021 12:39 pm
by gwhite
I'd ask on the MakerGear forum. That's very odd.
http://forum.makergear.com/index.php
Re: Extruder 2, wrong direction
Posted: Fri Sep 24, 2021 9:21 pm
by zemlin
That would be in firmware, not the slicer. Definitely check with Makergear, but it's a simple wiring change to reverse a stepper if needed.