I usually use S3D with a leapfrog creatr dual .
My calibration test is a 30mm hollow cube.
I'm trying now to use S3D with my FlashForge Creator pro.
but even i use flashforge , replicator dual or replicaor 2 dual , my cube isn't at good scale .
when printed its a 28.3 x 28.3 x 29.8 ( XYZ ) instead of a 30 x 30 x 30
- Flashforge creator pro + markerbot desktop = 30 x 30 x 30 ( but ugly )
Leapfrog creatr Dual + S3D 2.2.0 = 30 x 30 x 30 ( nice )
Flashforge creator pro + + S3D 2.2.0 = 28.3 x 28.3 x 29.8 ( but nice )
What to do ?