tonyno
Posts: 164
Joined: Sat Jan 31, 2015 5:46 pm

Re: 2.2.1 Communication problems?

Tue Feb 10, 2015 12:59 pm

Yes, last time, I did wait. I'll watch it closely next time.

tonyno
Posts: 164
Joined: Sat Jan 31, 2015 5:46 pm

Re: 2.2.1 Communication problems?

Tue Feb 10, 2015 10:35 pm

Seems to have gotten stuck again well before the bed was cooled fully...

SENT: XYZ_@3D:8
RECEIVED: WORK_PARSENT:0
RECEIVED: WORK_TIME:0
RECEIVED: EST_TIME:0
RECEIVED: ET0:205
RECEIVED: BT:89
RECEIVED: MCH_STATE:27
RECEIVED: PRN_STATE:5
RECEIVED: LANG:0
SENT: XYZ_@3D:8
RECEIVED: WORK_PARSENT:0
RECEIVED: WORK_TIME:0
RECEIVED: EST_TIME:0
RECEIVED: ET0:203
RECEIVED: BT:89
RECEIVED: MCH_STATE:27
RECEIVED: PRN_STATE:5
RECEIVED: LANG:0
SENT: XYZ_@3D:8
RECEIVED: PRN_STATE:5

Note in lower-right of window still says "Cooling Down...", but, the bed dropped, I hit OK, and it's back at the Main menu.

If I go to the Machine Control Panel and click Disconnect, then, Connect, it's fine.

tonyno
Posts: 164
Joined: Sat Jan 31, 2015 5:46 pm

Re: 2.2.1 Communication problems?

Sat Feb 14, 2015 8:57 pm

Seems to be fixed, and then some, in 2.2.2! :D

Return to “Troubleshooting and Bug Reports”