Re: e3d cyclops
Posted: Wed Feb 11, 2015 12:05 pm
sorry this confusion is my fault, i received both cyclops and chimera at the same time.. this setup was for cyclops (single nozzle). Sorry for the mix up
Page 2 of 2
Re: e3d cyclops
Posted: Wed Feb 11, 2015 12:08 pm
here is my delta setup
Re: e3d cyclops
Posted: Tue Feb 17, 2015 2:00 pm
What board are you using? Im dying to use my cyclops but Ive been hesitant to get it all going with the CRAMPS and machinekit. Any advice on activating the second axis and all that in the HAL and .ini?
Re: e3d cyclops
Posted: Wed Feb 18, 2015 12:17 am
I have a bebopr++ with a pepper board, there was already a hal/ini built >.< sorry im not more help