haimiko
Posts: 16
Joined: Sat Jan 24, 2015 5:54 pm

High Extrusion Multiplier

Sun Feb 15, 2015 2:02 pm

I can't get S3D to extrude reliably (I get a "string of perls"), on my Robo3DR1, unless I set the extrusion multiplier to +1.35. I've seen other posts where users have their multiplier set below 1. I have no issue with extrusion with the supplied Mattercontrol software, where the multiplier is set to 1.0. Makes me think that the filament speed must be greater in Mattercontrol. Is this normal?

JoeJ
Posts: 1436
Joined: Sun Feb 16, 2014 10:52 am

Re: High Extrusion Multiplier

Mon Feb 16, 2015 7:16 am

Have you set your filament diameter correctly (see Other tab of FFF settings)?

Return to “Troubleshooting and Bug Reports”