slipshine
Posts: 86
Joined: Sat Mar 16, 2013 10:27 pm

Possible Bug on Infill

I was working with the infill angles and the defaults are 45° and -45°.

I cannot seem to set a angle to Negative like the defaults.
Simplify3D
Site Admin
Posts: 310
Joined: Sun Feb 10, 2013 8:28 pm

Re: Possible Bug on Infill

You are correct. Right now the input is restricted to 0-360 degrees. You could enter "315" instead of "-45" and it should do the same thing. I'll make sure we allow negative input angles for the next update though. Thanks for the request!
slipshine
Posts: 86
Joined: Sat Mar 16, 2013 10:27 pm

Re: Possible Bug on Infill

No problem that was basically what I did. I just got nervious when I couldnt put it back to the default.

Thanks guys.

Return to “Troubleshooting and Bug Reports”