User avatar
jimc
Posts: 1124
Joined: Wed Aug 28, 2013 11:02 pm
Location: mullica, nj
Contact: Website

Re: Surface problems - what to adjust?

Mon Apr 06, 2015 9:00 am

just another thing to note. these settings will be impossible to nail down if the moisture content of your filament is too high. if its too wet it will have an inconsistent ooze.

MikaMa
Posts: 24
Joined: Fri Mar 27, 2015 2:29 pm
Location: Finland, JKL

Re: Surface problems - what to adjust?

Mon Apr 06, 2015 9:16 am

Don't think it's moisture. The problem areas are ALWAYS the same. Exactly the same spot. Also tried with 2 different filaments and same problems, same areas

MikaMa
Posts: 24
Joined: Fri Mar 27, 2015 2:29 pm
Location: Finland, JKL

Re: Surface problems - what to adjust?

Mon Apr 20, 2015 8:11 am

Just wanted to notify here that everything was caused by my stupidity :). Slicer works well now that I have read and studied a lot about printing settings etc.

Return to “Troubleshooting and Bug Reports”