So I've been getting this odd bug. It seems to happen mostly at the start of a print, but I'm not sure it doesn't happen elsewhere. I'll hit the run button, and suddenly it will start retracting... A LOT. Most times I won't seem to notice it until I here the *snap* of the filament hitting a support strut. I saw it last weekend right after I got the software and a few random times since, but it doesn't seem like there is a reason. After it happens, I hit the emergency stop, feed the filament back in, and it prints fine. I do know it happened once after I hit stop print, but I don't know what might cause this odd error.
My machine is the Trinity Labs Aluminatus, but it should be similar enough to a mendelmax/reprap/AO-100...
