22MIL2DAY
Posts: 53
Joined: Thu May 30, 2013 10:51 am
Location: SARASOTA FLORIDA

Can't Preview G-Code

Thu Aug 29, 2013 12:50 pm

I am unable to see any graphics when previewing the just created G code

dalew8abz
Posts: 120
Joined: Mon Mar 25, 2013 12:14 am
Location: Cleveland Heights, Ohio USA (4 mi. from MakerGear HQ!)
Contact: Website

Re: CAN'T PREVIEW "G" CODE

Sat Aug 31, 2013 9:47 pm

I assume you figured this one out. Just slide the "End" slider to the right. The sliders let you show layer-by-layer or line-by-line how the printer will move, but the preview comes up with both sliders full left, which shows from the start of the print to the start of the print. Since "x minus x equals zero" nothing is shown. I added a "feature request" that the preview window come up as a default with the "Start" slider full left and the "End" slider full right, rather than both at full left, so the whole preview is shown and you don't have to DO anything to see it. Perhaps this will happen in 1.1.6...

Return to “Troubleshooting and Bug Reports”