Everything goes according to plan, extruder moves to front left. bed & extruders heat up and then - nothing.
I'm pretty sure there's a missing command in the gcode - but as I never managed to get it working with s3d version 2.0 either - I don't know what's missing.
Dual printing works fine from makerware, well i say fine - as fine as makerware prints are compared to s3d prints.
So I know there's nothing wrong with the printer.
I'm running firmware version 1.0 and everything else works fine. So I'm pretty sure it's not that either.
I've tried just using two processes but it just complains that it's not configured for dual print and won't heat up both extruders.
Pretty sure it's an issue with the start up gcode.