Posts: 220
Joined: Sun Feb 02, 2014 4:40 pm


Mon Oct 12, 2015 1:50 pm

I have model of a hand where the printspeed drastically reduces speed at some points in the perimeters, thus making bulges that
is visible on the outside.

What is this? Bad model with too many small moves?

Posts: 7
Joined: Tue Apr 15, 2014 6:32 am

Re: Slowdowns=blobs

Mon Oct 12, 2015 3:45 pm

look this topic, perhaps is it the same problem

Posts: 1435
Joined: Sun Feb 16, 2014 10:52 am

Re: Slowdowns=blobs

Tue Oct 13, 2015 6:00 am

The cooling settings can slow down your printing speed. I would expect that would occur for small layers like maybe the last few fingers of your hand model. You can set the minimum cooling speed slowdown to limit how slow the print will go due to cooling.

Return to “Troubleshooting and Bug Reports”