Issue with using S3D with a M3d and wrong gcodes
Posted: Fri Dec 04, 2015 1:29 pm
Hello all,
I was wondering if someone could point me in the right direction here. I am relatively new to using S3D so this may be something I have overlooked. I am importing .stl files. I click on the Process and go through the menus as much as I understand and check settings. I hit the prepare to print and then save a gcode file and load into m3d software via load print job. The m3d software goes through the processing and warming up and then fails with an unknown gcode. I think I added the m3d printer correctly to S3D. Not sure what I am missing here. Does anyone have experience with the m3d and getting this to work?
Regards
MarkH
I was wondering if someone could point me in the right direction here. I am relatively new to using S3D so this may be something I have overlooked. I am importing .stl files. I click on the Process and go through the menus as much as I understand and check settings. I hit the prepare to print and then save a gcode file and load into m3d software via load print job. The m3d software goes through the processing and warming up and then fails with an unknown gcode. I think I added the m3d printer correctly to S3D. Not sure what I am missing here. Does anyone have experience with the m3d and getting this to work?
Regards
MarkH