Posts: 4
Joined: Tue Apr 21, 2015 2:26 pm

Ooze shield crosses the part

Mon Feb 01, 2016 3:58 am


While printing a dual extrusion part with an independent dual extruder printer and with "ooze shield" enabled I have seen that on extruder change, the new one starts the ooze shield on the opposite side of the part, I mean, it crosses the part before starting the ooze shield which results on a dirty part as in the following image:
Is there any setting to prevent or set where your extruder is (right/left) so that the ooze shield algorithm starts on the nearer point of its "idle position"?

Thank you

Posts: 2005
Joined: Wed Aug 05, 2015 7:23 am

Re: Ooze shield crosses the part

Mon Feb 01, 2016 9:49 am

Did you input the correct toolhead offsets in the G-Code tab? That will probably make a difference if you didn't set them (or used the wrong values)

Return to “Troubleshooting and Bug Reports”