Vexelius
Posts: 3
Joined: Tue Mar 29, 2016 12:48 am

Wanhao Duplicator 4 - Shifting issues on dual extrusion

Tue Mar 29, 2016 1:31 am

Hello, everyone!

I am starting to try out dual extrusion in my machine, and I have noticed that so far, the prints come out with a small but noticeable shift. For example, this cone:

Image

After asking for help in another forum, I was told that the problem could be fixed by setting up the toolhead offset, but that I could only do that using the Sailfish firmware in my 3D printer. I am currently running the stock firmware, and I would like to see if there's an alternative to set up the toolhead offset from Simplify3D, without having to change my printer's firmware.

Thanks for your replies!

Return to “Troubleshooting and Bug Reports”