Exactly. On top of that i have only half a clue what i am doing. So i have a "stock" process ie the way simplify set it up initially.
Then i only change ONE setting and test so i can try to see what it does. I altered the multiplier because someone told me to.
Now. What happens when i get different widths in different parts of the same model for no apparent reason. Its not filament since the change is coincident to the model and not place time or filament.
Ie the same part of the model is always thicker and the same part of the model is always thinner. Consistently. This would not be the case if it was variance in filament.
In fact i have one piece where 90% of the model is a desired 1mm thick (i now think this is the abnormal part of the model after reading the pdf you linked too which would also explain the rougher finish on these thicker parts) and the thinner part of the model is "correct" as per the settings (and has a nice clean finish). The other part is for some reason printing extra thin/weak. Look at my other video just before that one to see what i mean.
What is causing the wall thickness to change mid print? I dont think its the model since i am printing vase spiral mode. But for some reason when printing non circles i get 1mm thick wall but when peinting a circle with no deviation i get .54mm even in the very same print. When it dips below .5mm is when the parts fail and become brittle. Auch as the mod secrion of the rocket. For some reason with zero sertings change it prints that entire section 125mm long at .48mm and it just crumbles.
The bottom it prints at 1mm for some reason and then at the top when it goes full circularized it prints at .54mm
The nose portion it prints at .54mm and its thin but still strong and flexible but then reverts to 1mm thick at the tip of the cone for some reason. You can even hear the tone of the printer change at this point ie its by command.
And then i print a marvin and it comes out absolutely stunning. Same settings. Very weird.