Posts: 238
Joined: Tue Aug 26, 2014 5:23 pm

Re: Line in the start outer perimeter (not a blob)

Wed Apr 27, 2016 10:49 pm

So there is overextrusion at the beginning of the outermost perimeter.

Check that "Outside-In" on the Layer tab is set. So after a layer change, the infill perimeter should print before the visible outline layer... any anomalies with the stop/start of extrusion after layer change should be hidden from view.

If that is set, then try a negative "Extra Restart Distance" on the Extruder tab. A positive value will prime the nozzle, a negative should "starve" the nozzle... hopefully evening out the beginning of the layer.

Return to “Troubleshooting and Bug Reports”