dorsai3d wrote:You've got the option "Merge all options into a single solid model" enabled. That fills in any area that is completely outlined by the model, and is why you're getting solid layers like that. Disabling that allows it to slice perfectly fine for me.
PS: Rafts are bad.
That was it! Thnx!
Not sure what this option is for.............but I don't need it
PS: What is your thing against rafts? For me it works since sometimes the model (ABS) comes curling up a little bit at the corners. I'd rather have the model doing that at a raft than at the model itself.
Also, sometimes I use a little ABS slurry to 'glue' the model to my heated bed, but it works a little bit too well:P, So getting my model unstuck from my heated bed, I risk breaking the model, since it is so stuck to the bed...it's easier to first get it unstuck from the raft.