To print transparent models with clear PETG I bought a 0.7mm nozzle to be able to work with 0.5mm layer height.
But setting the new nozzle size I remarked, that S3D is ignoring these settings completely when slicing.
So I experimented with a lot of different nozzle settings and compared the slicer results. The attached picture is the slicer result for a model with 0.9mm thick walls. This result I got for for all settings I tried, independend from the nozzle diameter and extrusion width I tested. Even if I set the nozzle diameter to 0.7mm and the extrusion width to 0.9mm (the real wall thickness) S3D generates 3 traces for every wall resulting in a wall thickness of more than 3mm.
Where I made the failure?