I have a Mac operating a XYZ Da Vinci 1.0 over USB. I'm still a bit new to Simplify3D.
Every time I start up the 3D printer, Simplify3D defaults to the wrong serial port, and I have to manually change the port in the Machine Control Panel each time.
There are just two ports on the list. S3D defaults to /dev/cu.Blutooth-Incoming-Port, when it should be /dev/cu.usbmodem14321. I've looked around at where I can change this default but there isn't anything in Preferences or Firmware Configuration. Any ideas?
I am running a Malyan M180 from a Mac and I'm having exactly the same problem. The com port defaults to /dev/cu.Blutooth-Incoming-Port. In my case it should be /dev/cu.wchusbmodem14321.
It does it whether or not the printer is on and connected, and even after I've used Simplify with the correct port and restarted it.
Is there any way to specify the correct port as a user preference?