I am sorry if this is a beginner question, I am new to 3d printing and I just purchased simply3d. But I am totally lost. I am trying to print this: http://www.thingiverse.com/thing:1953745
So there are clearly a number of sections with unsupported areas, most notably the bottom of the helmet. I am trying to figure out the right way to do this. It seems like I have to force simplify3d into added supports by setting the degrees to 10.
So here is the print from cura:
Here are supports added in simply3d:
I am just not sure if I am doing this right or if there is another to add this type of "support"? Maybe its not called supports what I am trying to add.