Hi,
My starting sctipt consists of a G28 to home all axes, followed by a G29 to use BLTouch for bed leveling. The leveling ends with the hotend located at the upper rightmost location, where it goes up for a few centimeters, performs a retraction move and then goes to the lowest layer to start printing at the required coordinate. My question is about that retraction movement. It doesn't follow the general retraction parameters. In fact it is probably too fast, as my extruder isn't able to follow it and stutters. Is it something that is set by Simplify3D or is it Marlin's function? How can I set it to a slower speed? (Note: All my other retractions are following whatever I set at the retraction settings).
Thanks