Posts: 13
Joined: Sun Feb 09, 2014 9:25 am

Selective layer filling - Is it possible

Mon Feb 24, 2014 1:55 pm

Hi there,

I am trying to print a human head using simplify3d. While i like the multiple process approach in Simplify3d i am wondering whether we can have more granular control over infill pattern within each process. For instance, is there a way to infill areas less than say 10mm2 but not more than that. In doing so, i will be able to have infill in the areas marked in red (see attachment) but no the interior of the head. This will particularly help because gaping holes will not be seen and material could be saved by not infilling the interior.

Your comments and thoughts welcome.

Selective Infill.jpg
Selective infill - example

Return to “Troubleshooting and Bug Reports”