knctrnl
Posts: 4
Joined: Thu Mar 09, 2017 8:01 pm

TPU issues

Thu Mar 09, 2017 8:04 pm

I am having some problems printing TPU parts.

My top layer ends up looking like has divots or holes in it. Very ugly finish.
Also the area above my supports looks terrible and is hard to remove supports.
I am using CreatorPro 2016 model with sainsmart TPU.
Nozzle temp is 220 also tried 210 and bed temp is 80.
Print speed is at 1600.
Anyone had similar issues?

horst.w
Posts: 852
Joined: Fri Oct 17, 2014 5:00 pm

Re: TPU issues

Fri Mar 10, 2017 5:15 pm

.... you have forgotten to attache your FACTORY-file here.

Without this reasonable advices are not possible.

Regards

horst.w, GER

knctrnl
Posts: 4
Joined: Thu Mar 09, 2017 8:01 pm

Re: TPU issues

Sat Mar 11, 2017 2:28 pm

Sorry. Here is the file.
Attachments
go pro top 3.factory
(1.58 MiB) Downloaded 126 times

Return to “Troubleshooting and Bug Reports”