Page 1 of 1

Manual place supports in cross-section mode?

Posted: Sat Jun 17, 2017 3:39 am
by TheRiddick
So you can auto generate supports, but how do you manually place them while in cross section mode?

Re: Manual place supports in cross-section mode?

Posted: Sat Jun 17, 2017 7:59 am
by MasterFX
It is the same. Never tried?
support.png

Re: Manual place supports in cross-section mode?

Posted: Fri Apr 19, 2019 7:48 pm
by twistedream13
I am running into an issue where, in cross section mode, I cannot place support material in a fully enclosed space. My thought it that the cross section mode is just making the part invisible, and so when I try to place support material, it still thinks my cursor wants to place the support on the outside of the object.