Posts: 1
Joined: Tue Jun 27, 2017 9:03 am

Support missing using "Extra inflation distance"

Tue Jun 27, 2017 9:21 am

Hi All,
We recently upgraded our gigabot with a dual extruder to be able to print with PVA. The models we are printing are typically models with more overhanging layers. To get a good print with PVA and PLA I’m trying to extend the PVA support with “extra inflation distance” (with for example 5mm) Problem is that the software necklets the support needed to support the itself on higher layers. I attached both model and print preview to illustrate the problem.
Anyone any ideas how to fix this?

Jelle van der Meer

print preview.PNG
print preview with 5 mm extra inflation distance

Return to “Troubleshooting and Bug Reports”