I don't know what you are getting at, but i have written a lot about it.
Velleman K8200 with a ramps 1.4 and a lcd. Windows 7 home 64bit, 12Gb memory, I5 cpu, printing over USB, have done for years without problem up till S3D V4.0.
With v4.0 and 4.01, pauses randomly on all prints. Never the same spot what i can gather. about 200-1sec. If going back to 3.1.1 NEVER pauses whatsoever on any print.
Homebuilt delta with smootieboard and smootihie firmware on ANOTHER computer ALSO running Win 7 home 64bit, core2duo with 8Gb memory, also printing via USB.
With 4.0 and 4.01 pauses 200ms to 1sec, ALSO randomly on EVERY print. If i print with 3.1.1, NEVER any pauses.
Both machines have NO GAMES or other junk installed but webbrowser, blender and netfabb.
so you are STILL saying it is my USB it is wrong with?
dkightley wrote: ↑
Thu Mar 08, 2018 12:46 pm
Okay.....this is getting like a bloody pantomime! "There's a bug!" "No there isn't" "Oh yes there is!"
From what has been said on more than one thread....there must be something going wrong. And nobody is providing any useful diagnostic information to allow the dev guys at S3D to investigate whether or not there is an issue in S3D.
So.....let's stop the dramatics...and document where there is a printing problem, and where printing is okay!
Makerbot Rep2 on Windows 10....printing to USB - never has been an issue.......printing direct - pauses started couple of years ago at Win10 upgrade. Stopped printing direct & have never tried since.