[SOLVED] Coasting Distance: Has no effect?
Posted: Sat Aug 12, 2017 4:24 pm
I've been using S3D for a number of years now, pretty familiar with it, but I'd never used the 'Coasting Distance' option : Have a bigger nozzle, getting some blobbing a the end of the extrusion that wipe isn't addressing, so I figured I'd try this.
And try I have: Probably 5 different test-cylinders broken into 5 processes each with difference coast settings. And none of them look any different. Tested this in both S3D 3.0 & 4.0. Save factory file, closed/reopend the software, turned the checkbox on\off \ resave etc. It just does, nothing.
Here's a pic of my end results. The nozzle is traveling screen left -> right, so the left side of the zipper coasting should address. I also turn off my fan briefly between sections so they're easier to tell apart. In this case, all the same: Here's a pic of the gcode: Clearly there should be some gaps forming, since I put some really big values in there (2mm for example): I did another test with even *bigger* values, still no effect.
Here's my factory file for inspection: I'm using a custom build core-xy printer with RepRap Firmware runnnig on RADDS, .6mm volcano nozzle & bondtechBMG extruder.
Any thoughts as to why this would be happening? I'll attach my gcode in the next post.
And try I have: Probably 5 different test-cylinders broken into 5 processes each with difference coast settings. And none of them look any different. Tested this in both S3D 3.0 & 4.0. Save factory file, closed/reopend the software, turned the checkbox on\off \ resave etc. It just does, nothing.
Here's a pic of my end results. The nozzle is traveling screen left -> right, so the left side of the zipper coasting should address. I also turn off my fan briefly between sections so they're easier to tell apart. In this case, all the same: Here's a pic of the gcode: Clearly there should be some gaps forming, since I put some really big values in there (2mm for example): I did another test with even *bigger* values, still no effect.
Here's my factory file for inspection: I'm using a custom build core-xy printer with RepRap Firmware runnnig on RADDS, .6mm volcano nozzle & bondtechBMG extruder.
Any thoughts as to why this would be happening? I'll attach my gcode in the next post.