SpoonUnit
Posts: 4
Joined: Mon Mar 28, 2016 5:40 am

Layer start pos not honored for external single extrusion

Fri Aug 18, 2017 4:57 am

Consider the following setup

Image

And a simple model (a cylinder (1mm edge thickness for the most part)

Image

If I print this with a 0.5m nozzle, my start points will be honored

Image

If I switch to External Thin Wall Type = Allow single extrusion walls then I no longer see the start line

Image

The problem then is a little easier to see when we double up the model count. Here's the standard process without single extrusion

Image

You can clearly see the requested start point being honored. And now with single extrusion

Image

The requested start points are no longer honored

Return to “Troubleshooting and Bug Reports”