Posts: 2
Joined: Mon Jul 06, 2015 7:30 am

Can you set which wall will be printed first?

Fri Sep 01, 2017 12:37 pm

Hi there!
Say I want to print a cylinder which has thin walls; so thin there will just be 2 outer walls, 1 on each side, and no filling at all. Is there a way of setting which one of the outer walls should be printed first?
If I'm correct, the "Outline Direction" setting doesn't apply to this case, because both walls are outer walls.
The picture below shows a detail of the wall. I'm trying to print the outer wall that's inside the part first.
Any thoughts? :)

Return to “Troubleshooting and Bug Reports”