Just another question on the bridge layer, that's added to supports... I seem to have a height issue, where I now have to sand off the bridge layer, as it won't come off the part.
- Printed item, with Bridge layer in view
- Bridge layer in S3D
In my support settings, I have 2 layers dense support at 50% - these come out easily, no issue at all. Setting for vertical separation is 1 layer each.
So.... shouldn't a bridge layer come off also, when removing support? This bridge layer is completely fused with the 1st solid layer and I can't seem to be able to remove it
(other than sanding it out, that is).
I have a layer height of 0.2mm & the top of the bridge layer is produced on the 20th layer: so that puts a printing surface for the 1st solid layer at 4.0mm height - exactly where it needs to be. But as I can't remove the bridge - I now have to sand the 0.2mm out.
Is there maybe a setting that I've got wrong? If someone could indicate where to look, that would be great! It's good to read, (above post) that I can temporarily switch off bridging - but if there's a better way to do it...
Thanks!