Shows build time, filament length, and material cost.
Preview mode now takes over the interface.
No need to name gcode each time.
Scale each axis independently.
Scale/position updated as you make the changes.
You can inflate the support so that it will actually work (I still think this should be automatic - if an overhang goes into a support grid location even a little, that location should be on by default).
MakerGear M2 profile updated.
You can set perimeter start points.
Speed still in mm/minute instead of mm/sec.
Honeycomb infill option would be nice.
I can live with this.
Last edited by rsilvers on Fri Apr 11, 2014 1:10 am, edited 2 times in total.
one thing i have noticed over the past 8mos of watching feature requests here is one person wants one thing then another wants the same but another way, and so on. only way to really make everyone happy is to have the feature adjustable. now you know if they just set the inflation to 1mm someone would come along and bitch that its too big and it should be at .5. i do think its smart to make the values of everything customizable. if you like 1 or whatever i think you can just set it and forget it.
Support is already is adjustable by the overhang angle that defaults to 45 degrees. Beyond that, the software should ensure that any area that is under that angle has support under it - as other slicers do for a good reason.
Even if they keep the inflation setting, they should also do the real fix, which is probably just one line of code.