Dear all
I am new to simplify3D
using until now repetierhost with integrated slic3r.
My problem
I want to pint a complex vase.
I sliced it with Slic3r, it took 45 minutes to slice and will give me a 16 hour print time.
I sliced it with Simplify 3D, slice time took 45 seconds and it will give me a 31 hour print time.
Slicing speed is very good, but print time is double
I think it is caused by a lot of to me pointless travel of the extriders. The vase has a circular crossection.
However printing is not done in a curcular way.
It will print a short bit on one side then move to the other side to print a bit, then move again to another area and print a bit
the exutruders seem to spend more time travelling than they do printing
how to prevent this ?
hope someone can help me