I'm using S3D 4.0.0 and a Creator Pro.
I currently have two filaments leaded into the printer: a PLA on the left and TPU on the right.
I've been printing some TPU components today and wanted to swap to PLA for the final piece. When I swapped profiles, everything looks like it's set correctly (including temperatures) but when I go to print it continues to try to use the TPU temperature settings. I'me setup as follows:
However when I go to print, it heats beyond those targets:
I've tried restarting S3D and the printer without success.
Any ideas what I'm missing?
TIA.
