shasselberg
Posts: 21
Joined: Thu Mar 31, 2016 9:16 pm

Prime Tower, Ooze Shield and First Layer Setting

Mon Nov 13, 2017 9:17 am

Prime towers and ooze shields don't stick, but the print itself does. Are we certain that they use the same first-layer settings as the model? If I print the first layer at a higher thickness, does the prime tower and ooze shield use that setting?

brian442
Posts: 1243
Joined: Mon Nov 28, 2016 5:35 am

Re: Prime Tower, Ooze Shield and First Layer Setting

Tue Nov 14, 2017 11:00 am

Yes, they do. You can check the gcode to easily verify this yourself too ;)

shasselberg
Posts: 21
Joined: Thu Mar 31, 2016 9:16 pm

Re: Prime Tower, Ooze Shield and First Layer Setting

Tue Nov 14, 2017 11:06 am

Thanks.

So, then, why don't they stick when the rest of the print does? Watching the beginning it seems to have insufficient flow, when the rest of the print is fine.

Predaxis
Posts: 5
Joined: Tue Jul 09, 2019 8:17 pm

Re: Prime Tower, Ooze Shield and First Layer Setting

Wed May 27, 2020 11:23 am

I see this is VERY old, but I am having the exact same symptom. Was anything ever found around this?

Return to “Troubleshooting and Bug Reports”