Hello,
On my K8200 when printing the plate and head start to heat without a home is done.
The filament flows on the plate and when the home starts it makes deposits that hamper printing.
To correct this I am forced to change the Gcode to place the home at the beginning of printing, it's tiring ...
Yet in the beginning script in the slicing interface there is the G28 ...
On my dreamer the head goes off-shelf during the heat, yet the K8200 is also in the list of printers well managed by S3D ...
If you with a solution?
Or it must be said that S3D is not directly compatible with a K8200.
Thank you for your answers
Home too late solved
Last edited by statis on Mon Jan 15, 2018 4:55 pm, edited 1 time in total.
Re: Home too late solved
See https://forum.simplify3d.com/viewtopic. ... 5&start=10 for correct place G28
