ok, but i have not had this "problem" with pre 4.x versions. I have never seen it and i have tried everything i think.
And pre 4.0 does work without the gap showing and same material preset.
And it is NOT some small itsy tiny extrude that does not show.
dkightley wrote:I know you will disagree vehemently with me over this....but this is NOT a bug!
Infill width 0.5mm
Available width for infill of say 2.04mm
Infill outline overlap of 10% max...i.e. 0.05mm
The infill will be 40 extrusions with a gap of 0.04mm. With the max outline overlap set at 10%, the slicer CANNOT place another extrusion.....therefore a gap each side. Change the infill outline overlap to 50%, then the slicer can now place an extra two extrusions, each overlapping the perimeter extrusion....NO GAP!
For your factory file, increase the outline overlap to anything over 40%...and NO GAP!
This is how the software is designed to work......