support printing offset from part

[Rebekah_harper]

hiya all,

I have discovered that when I am printing with the left extruder (all aspects of print) it's printing the supports away from my part.

I cannot see why it is doing that

GCode attached.

FFF. attached in next post

[Rebekah_harper]

here is the factory file

[Rebekah_harper]

I think I found the problem but will check when I get home.

the Code is saying that M135 T0 which if I am not mistaken is the right extruder.

point being, I don't use the right extruder for this print. hmmmmm

hope this is the problem.

if any one can confirm this that would be grand.

cheers

becky