Maybe this already exists (I am new).
Is there any way to change the pattern of the support material? Not the infill, but the support material.
Right now it is rectangular. It would be nice to be able to adjust the angle of the pattern or change the pattern shape.
I might want a low percentage support, but sometimes it misses the feature I am trying to support.
It is not a deal breaker.
Just an idea.
-
bray.christopher
- Posts: 62
- Joined: Fri Jun 19, 2015 11:24 pm
Re: Support Pattern
You can adjust the support angles on the Support tab of your FFF settings. FWIW - I have always used the default values and I have no reason to want to change.
-
bray.christopher
- Posts: 62
- Joined: Fri Jun 19, 2015 11:24 pm
Re: Support Pattern
Thanks! Changing the angle worked great for me.
Now set my support pattern angle to 45 and it will catch overhangs in the X and Y axis.
Now set my support pattern angle to 45 and it will catch overhangs in the X and Y axis.
