Floating support in print preview

[Rebekah_harper]

hiya team,

for some reason I have a few layers of support that is floating in mid air. I have attached the factory file so it should recreate it.

It spans between two holes across the front of the chassis. Why is this and how do I get it rid of it.

many thanks

Becky

[JoeJ]

It looks correct to me, it's just inflated by 1mm since you have that in your settings

[Rebekah_harper]

but it's connected a gap between the two holes that's 50mm with nothing above it for it to support. I added the 1mm because of the features lower down.

I would have thought it would just extend the support 1mm either side of the holes not right accross. can remember this happeing in previous version.

[JoeJ]

It expands equally in all directions. Has always worked that way.