Hello,
I am fairly new to 3D printing. I have just invested in S3D, my issue at the moment is that my prints are coming out with gaps between the perimeter and the infill. Is there a setting I can change to fix this?
I am printing PLA @ 210 - 205 on a CTC 3D printer.
Re: Gaps
Try increasing your outline overlap?
viewtopic.php?f=8&t=1953
Assuming it's not currently set to "0", there might be another issue causing the problem but unfortunately I don't have anything coming to mind immediately.
viewtopic.php?f=8&t=1953
Assuming it's not currently set to "0", there might be another issue causing the problem but unfortunately I don't have anything coming to mind immediately.
