Reading through a few Windows discussion sites, I thinh I might have spotted a common theme that might point to a possible workaround until Micosoft get a fix sorted.
The USB issues that some are experiencing seem to be due to a fault in the wake from sleep command issued through USB3 hubs....and suggestions have been to connect via a direct USB port as opposed to via a hub.
This has got me wondering if those 3D printer users who are experiencing stuttering, etc, are connected to an USB3 hub...possibly even an add-on USB card.....and those who have not had issues are connected via a non-hub USB connector, eg direct mb connection. I would also question if anyone who connects using older USB, eg USB2, has issues or not.
Any thoughts anyone? Or am I talking rubbish??