Infill percentage tends to be the only thing I change on a per-print basis. In the FFF settings, moving that slider appends the print profile with the word "modified" in parenthesis.
Knowing that a profile has been changed is invaluable, but because my profile says "modified" every time I print the feature's value is obviated. I need to rely on memory anyway and wind up exporting the profile (appended with the date) incessently for fear of losing truly state-of-the-art settings.
Suggestions:
-Stop the infill percentage slider from activating that flag.
or
-Have the settings revert to the completely unmodified profile when starting a new prorcess or restarting the program. This would be my preference; I find it a bit awkward that a change to the profile sticks when restarting the program even without explicitly saving the change. I would rather have a clean slate every single time, where a "clean slate" is only the profile that's selected in exactly the state it was in when I explicityly saved it.
~Justine
