Bridge settings not applied to perimeters
Hi all, new user here. Been printing for a few days now and so far I love the software. However, I've noticed when bridges are sliced the outermost perimeters don't have the bridging settings applied to them, (they're blue instead of yellow in the preview) and it really makes the bridges look a lot worse than they could. I've searched for any settings related to this issue and can't find any. Can anyone help, or is this a bug in how bridges are sliced?
Re: Bridge settings not applied to perimeters
I've posted about this in the past. No, simplify3d does not apply bridging overrides to perimeters. Yes, it sucks. 
I've contacted support about it and they say it's on the list of stuff to do, but they have no ETA for implementation.
Please contact support directly and request this feature!
The more folks request it the more likely they will be to implement it.
I've contacted support about it and they say it's on the list of stuff to do, but they have no ETA for implementation.Please contact support directly and request this feature!
The more folks request it the more likely they will be to implement it.