hello! I have a problem with my Wanhao Duplicator i3 I do not know how to solve! I used the "Cura" before, and it worked perfectly until I bought S3D yesterday.
When I set the (FFF) profile for wanhao i3 it will not extrude. So fixed some with the settings
> Nozzle Diameter 0.40mm (actual size)
> Extrusion Multiplier 0.90-1.00
> Extrusion Width (Manual) 0.45
Then it will extrude .... but in rough Quality
I want to change the resolution (Quality) to finer
but then refuses to print / extrude,
It will extrude but in a super small amount and that causes the PETG to not stick to the heatbed (BuildTak)
It just gets a large lump of PETG due to plastic getting dragged around on the headbed.
Iv'e tried different tempratures,
Im 100% sure that my Heatbed is in level. (messured with a Dial Indicator)
has anyone had such experiences, and managed to find a solution?
