Hi everyone,
a simple, but annoying bug: everytime i cancel the setpoints of the fan control in the cooling tab and than i close the window o simplify, when I launch again simplify I find two new setpoint one at layer 0 with fan speed 0 and one at layer 1 and fan speed 100.
If i don't want fan in a process everytime I launch a new window of simlify I need to cancel that setpoint.
My configuration is Simplify 3D 3.0.2 on Windows 10.
thank you very much!
-
guidogamerro
- Posts: 1
- Joined: Wed Dec 09, 2015 10:38 am
